User`s guide

Introduction
PC-250, PC-260, and PC-300 User’s Guide Page 9
Install the ISA Bus Board
1. Connect the ends of the ribbon cables labeled CARD to their
respective connectors on the ISA Bus Board.
2. Install the ISA bus board in the PC.
3. Check all connections. See the illustrations in Chapter 2, Installing
the Hardware.
4. Replace the computer’s cover and verify that the system boots and
operates normally.
Install the Software
1. Write protect the installation diskette.
2. Type a:\install from the DOS prompt and follow the instructions on
the screen.
3. Restart the system for the changes made to the CONFIG.SYS and
AUTOEXEC.BAT files to take effect.
You are ready to use your Card Reader.
What to Do Next
The installation and operation of most types of memory, ATA and
communication I/O cards is fully automatic under MS-DOS and
MS-Windows. Once you’ve installed CardTalk you can use these cards
without further installation procedures.
Additional Drivers
Certain I/O cards, such as the following cards, may require their own
drivers:
• LAN
• SCSI
• other specialized card types