User manual

Actiontec USB/Ethernet DSL Modem User Manual

Chapter 4 Setting up Static IP Addresses

Configuring for a Block of Static IP Addresses

To set up a the Modem to use a block of static IP addresses:

☞

Note: To complete this procedure, the Internet Service Provider

(ISP) worksheet or welcome letter must be available to consult.

If no worksheet has been provided, contact the ISP.

1. Open the Web browser. In the “Address” text box type:

http://192.168.0.1

then press Enter on the keyboard.

2. The Home screen appears, set to the “Status” tab. Select Advanced Setup from

the row of tabs at the top of the screen

☞

Note: If the Home screen does not appear, make sure the

Ethernet cable is properly connected to the Modem.