Installation Guide Owner manual

READ FIRST! Find the Coaxial Outlet near your Router/

Gateway. If there is already a coaxial cable plugged into the

outlet, connect the ECB2500C MoCA Network Adapter as displayed

in Figure A. If there is NOT, follow the diagram in Figure B.

Step

4 Place the WCB3000N Wireless Network Extender in an

area where your Wi-Fi signal is spotty (where Internet signal does

not reach or drops). You will need a Coaxial Outlet nearby.

Step

1 Connect the Coaxial Cable(s) to the Coaxial Outlet as shown

in either Figure A or B. Make sure you are using the appropriate

diagram for your home. See the Read First instructions above.

Step

5 Find the Coaxial Outlet near the Wireless Network

Extender. If there is already a coaxial cable plugged into the outlet,

connect the WCB3000N as displayed in Figure C. If there is NOT,

follow the diagram in Figure D.

Step

2 Plug one end of the Yellow Ethernet Cable into an

Ethernet Port on your Router/Gateway. Plug the other end into

the Ethernet Port on the back of the ECB2500C.

Step

3 Plug one end of the Power Adapter into the Power Port

on the back of the ECB2500C and plug the other end into an

Electrical Wall Outlet.

Step

6 Connect the Coaxial Cable to the Coaxial Outlet as shown

in either Figure C or D. Make sure you are using the appropriate

diagram for your home as described in Step 5.

Flip this Quick Start Guide over to continue

Installing the Kit

Figure A

Figure B

Figure C

Figure D

Step

7 Plug one end of the Power Adapter into the Power Port

on the back of the WCB3000N and plug the other end into an

Electrical Wall Outlet.

WCB3000N ECB2500C_InstllGd_H_MPAV EA kit QS4.qxd 10/15/13 3:46 PM Page 1

PAGE 1
WCB3000N ECB2500C_InstllGd_H_MPAV EA kit QS4.qxd 10/15/13 3:46 PM Page 1 Installing the Kit READ FIRST! Find the Coaxial Outlet near your Router/ Gateway. If there is already a coaxial cable plugged into the outlet, connect the ECB2500C MoCA Network Adapter as displayed in Figure A. If there is NOT, follow the diagram in Figure B. 1 Connect the Coaxial Cable(s) to the Coaxial Outlet as shown Step in either Figure A or B. Make sure you are using the appropriate diagram for your home.
PAGE 2
WCB3000N ECB2500C_InstllGd_H_MPAV EA kit QS4.qxd 10/15/13 3:46 PM Page 2 8 Dual-Band Wireless Network Extender +Ethernet over Coax (MoCA) Kit Can I change the wireless network name and password Q on the Wireless Network Extender to match my exising Step Wait until the Coax and Wireless Lights on the front of the Extender are GREEN. This may take a couple of minutes.