User`s manual

The Wireless Connectivity Expert

ACT-IR2x0L/IR220L+ (IrDA

)

User’s Manual

Page 12 of 44 Nov. 16, 2010

7. WINDOWS 2000 INSTALLATION GUIDE

Note1.: If you have not verified your computer BIOS setting, STOP here and go to Chapter 4 BIOS

SETUP VERIFICATION.

Note2: If your computer system has installed some devices on the same COM port before, you MUST

properly uninstall the devices first. ACT-IR200L/220L/220L+ would NOT work with your system

any more if the devices are uninstalled improperly because some drivers are still there and

cause conflicts with ACT-IR200L/220L/220L+ driver. You HAVE to re-install your Windows 2000

again.

Note3: If your computer system has installed an FIR device before, ACT-IR200L/220L/220L+ would

NOT work with your system any more. You HAVE to re-install your Windows 2000 again.

Note4: If you want to use Virtual COM Port in your application, STOP here and change

ACT-IR200L/220L/220L+ to USB-IR Dongle.

Following are the instructions to properly install the ACT-IR200L/220L/220L+ Dongle. You need a

computer system with at least one serial port available.

A. Connect ACT-IR200L/220L/220L+ serial adapter to the COM Port of Desktop PC.

B. Startup your computer system

C. Click on Control Panel.

D. Double Click Add/Remove Hardware.

E. On Welcome to the Add/Remove

Hardware Wizard, click Next>.

ACTiSYS Confidential Information

V 1.5.2.4