User`s manual

The Wireless Connectivity Expert

ACT-IR2x0L/IR220L+ (IrDA

)

User’s Manual

Page 6 of 44 Nov. 16, 2010

5. WINDOWS 98 INSTALLATION GUIDE

Note 1: If you have not verified your BIOS setup at this point, we strongly recommend you to refer back

to the Chapter 4 BIOS SETUP VERIFICATION

and verify your BIOS setup again.

Note 2: Verify that the COM port you will use to install ACT-IR200L/220L/220L+ has not been already

used or occupied by any hardware or software. We recommend users to completely delete any

files or drivers that can interrupt clean fresh installation of our product.

Note 3: You are trying to install an SIR product. Your operating system can always be upgraded to FIR

products. However you can never downgrade from an FIR product to an SIR product. Therefore

make sure that you have not previously installed any other FIR products on your system.

Followings are the instructions to properly install ACT-IR200L/220L/220L+ Dongle. You need a computer

system with Windows 98 already installed and at least one serial port available. The best choice for the

system is a desktop PC.

A. Connect ACT-IR200L/220L/220L+ serial adapter to the COM Port of Desktop PC.

B. Boot up your computer system.

C. Double Click My Computer on DeskTop.

D. Double Click Control Panel.

E. Double Click Add New Hardware on Control Panel Window.

F. Click Next>.

ACTiSYS Confidential Information

V 1.5.2.4