User`s manual

Before making a service call, Dlease check the followine:
SYMPTOM
Can not establish link
(General)
ACT-IlUOOW220L is
PROBLEM
* ACT-IR device and IR ready
device on the other side are not
aligned properly
@ Distance is not optimum.
@The power-saving feature in the
connected to and takes
power only from the
serial port of the notebook
computer, not working or
communication distance is
too short.
notebook computer either stops
or reduces power output from the
signal lines of the serial port to the
ACT-IR200L/220L devices,
e Certain notebook computer
requires you to set the Comm port
to “Serial” or “Infrared”, especially
when it has a built-in IR window.
File Transfer between IR-
* The infrared communication is
equipped PDA and ACT-IR
interfered.
device-attached host computer
For example, something blocks
stops before finishing up and
an error message appears.
out the infrared beam or the burst
of strong light source, etc.
Q
REMEDY
*Check to be sure units are
properly aligned & leveled.
@Check to keep optimum
distance.
@Set the “Power management”
control to “Advanced” or “off’
to enable power supplied from
computer serial port to ACT-
IR22OL/2OOL devices.
* Go to the appropriate control panel
specified in the user’s manual of your
notebook computer and set the
Comm port to “Infrared”.
) Check to find out the source of
interference and eliminate it before
trying again,
) If you were restoring data, simply
try again..
b If you were doing backup,
sometimes the PDA does not reset
its flags and keeps stopping
at the same position unless you press
the RESET button once. Be
very careful, DO NOT initialize
(press ON key and RESET button at
the same time) your PDA. Otherwise
you may lose all your data.