Owner`s manual

7 8

SurfacePreparation

Before starting any cleaning task, it is important to inspect the area for objects that could

create a hazard. Remove any objects from the work area that could be tripped over, such as

toys or outdoor furniture. Ensure that all doors and windows are closed tightly.

WaterSupply(ColdWaterOnly)

Only draw water through the unit. For use with cold water supply only. Water hose must be

at least a 1/2” (13 mm) in diameter. Flow rate of water supply must not fall below 2 GPM

(gallons per minute) [9.1 lpm (litres per minute)]. Flow rate can be determined by running

the water for one minute into an empty 5-gallon (19 L) container.

CAUTION

•Neverusethepressurewashertodrawinwatercontaminatedwithsolvents(e.g.

paintthinners,gasoline,oil,etc.).

•Dirtinthewaterinletwilldamagetheunit.Toavoidthisrisk,werecommendchecking

thewaterlter(locatedinsidethewaterinlet.TocleanitoutseeMaintenancesection).

•Alwayspreventdebrisfrombeingdrawnintotheunitbyusingacleanwatersource

andanadditionalaccessorywaterlterifrequired.

•Toprolongthelifeoftheunit,resttheunitfor5minutesafterevery30minutesofuse.

ASSEMBLY AND OPERATING INSTRUCTIONS ASSEMBLY AND OPERATING INSTRUCTIONS

Attach high pressure hose to the gun assembly

(hand tighten only).

Attach the inlet adapter to the machine’s water inlet.

Hand tighten only. (Some models come with inlet

adapter pre-assembled. Check your unit.)

Insert choice of wand to the gun and twist

¼ turn to lock in position.

Attach quick connect coupling to garden hose (hand

tighten only) and attach to inlet adapter.

Attach high pressure hose to the machine’s water outlet

(hand tighten only).