Owner`s manual

ManualsBrandsActive Products ManualsPower ToolsYE03

15 16

CLEANING AND MAINTENANCE

Connections

Connections on pressure washer hoses; gun and spray wand should be cleaned regularly

and lubricated with non-water soluble grease.

SprayTipsOnly

Clogging of the spray tips causes the pump

pressure to be too high and cleaning is im-

mediately required. You can clean the spray

tips by carefully inserting the needle, or a

thin, sharp instrument (i.e. paperclip) into

the tip to rid it of deposits.

WaterFilterScreen

The pressure washer is equipped with a wa-

ter inlet screen to protect the pump. If the

screen is not kept clean, the ow of water

to the pressure washer will be restricted

and the pump may be damaged.

1. To clean inner water screen, remove

quick-connector and remove the ﬁlter

screen from the pump inlet.

2. Rinse screen until it is free of debris

and blockage.

3. Replace screen and quick-connector im-

mediately to prevent any foreign matter

from entering the pump.

TROUBLESHOOTING

Disconnect the machine from the power source before making any repairs.

Symptom Cause Solution

Motor will not start. On/Off switch is in the

“OFF” (O) position.

Turn switch to the “ON”

( | ) position.

Power cord is not plugged in. Plug in power cord.

Extension cord is too long.

Extension cord is not

proper gauge.

Extension cord is damaged.

Replace extension cord

with either a 25’ (7.6 m)

14AWG cord or a 50’ (15 m)

14AWG cord.

Electrical outlet does not

supply adequate power.

Try a different outlet.

Tripped pressure washer

circuit breaker

Allow to cool, and restart unit.

Unit does not reach

high pressure.

Diameter of garden hose is

too small.

Replace with a 1” (25 mm) or

5/8” (16 mm) garden hose.

Water supply is restricted. Check garden hose for

kinks, leaks and blockage.

Not enough water supply. Open water source fully.

Water inlet ﬁlter is clogged. Remove ﬁlter and rinse in

warm water.

Pump is sucking air. Check that hoses and

ﬁttings are airtight. Turn

“OFF” machine, and purge

pump by squeezing trigger

gun until a steady ow of

water emerges through

the nozzle.

Output pressure varies high

and low.

Not enough inlet water supply. Turn water on fully. Check

garden hose for kinks, leaks

or blockage.