Installation Guide

Installation Instructions for

Aura Vent, Aura Solar Fan & Pop Vent

Retro-Fit Products

Lastly use the four #8 self-taping screws (included in

the box) to attach the vent heads. Screws should be

placed at 12:00, 3:00, 6:00, 9:00.

Now slide your

replacement

head over the

existing collar

Collar

Base

* Before you install, make sure that

the replacement cap is the right size

diameter for your existing base.

Remove the old turbine “head” off the

collar. Leave the collar attached to the

turbine base on the roof.

PAGE 1
Installation Instructions for Aura Vent, Aura Solar Fan & Pop Vent Retro-Fit Products * Before you install, make sure that the replacement cap is the right size diameter for your existing base. Collar Base Remove the old turbine “head” off the collar. Leave the collar attached to the turbine base on the roof. Now slide your replacement head over the existing collar Lastly use the four #8 self-taping screws (included in the box) to attach the vent heads. Screws should be placed at 12:00, 3:00, 6:00, 9:00.