Installation Guide

5777-5

Tail Pipe Installation with Roof Vent

Installation Instructions for RBV-5-C4-TP

Step 1:

Turn the vent upside down and make a

cardboard template from the flange. The template

should be the same size as the flange with the hole

in the middle.

Step 2:

Using the template, trace the square and circle

onto the roof as shown.

Step 3:

Remove cardboard template to show

the square and circle pattern.

Step 4:

Using a reciprocating saw cut out a hole in the roof

deck and remove all debris.

Page 1 of 3

PAGE 1
I nst al l at i onI nst r uct i onsf orRBV5C4TP Page1of3 Tai lPi peI nst al l at i onwi t hRoofVent St ep1: Tur nt heventupsi dedownandmakea car dboar dt empl at ef r om t hef l ange.Thet empl at e shoul dbet hesamesi zeast he f l angewi t ht hehol e i nt hemi ddl e. St ep3: Removecar dboar dt empl at et oshow t hesquar eandci r cl epat t er n. St ep2: Usi ngt het empl at e,t r acet hesquar e andci r cl e ont ot her oofasshown.
PAGE 2
I nst al l at i onI nst r uct i onsf orRBV5C4TP Page2of3 Tai lPi peI nst al l at i onwi t hRoofVent St ep5: Oncet hehol ei scutr eachi nt heat t i candpul lup t heductt hr ought hehol e. St ep7: Usi ngaZi pTi esecur et heFl exDuctt ot heTai lPi pe. St ep6: I nser tt hebot t om oft heTai lPi pet ot hef l exduct .
PAGE 3
I nst al l at i onI nst r uct i onsf orRBV5C4TP Page3of3 Tai lPi peI nst al l at i onwi t hRoofVent St ep9: PushFl exDuctbacki nt oat t i c,t henl i f tshi ngl est o i nser tf l angeunder neat h. 10A: Requi r edscr ew:#10x1. 5”st eelsheetmet alscr ew Tot alnumberofscr ewsr equi r ed=8 St ep10: Wi t ht heventi npl acesecur et hef l anget ot he shi ngl er oofusi ngascr ewgunordr i l l St ep11: Thi si showt heRoundBackVentshoul dl ookwhen f i ni shed.