Installation Guide

Active Ventilation Products, Inc.

311 First Street, Newburgh, NY 12550-4857

800-ROOF VENT (766-3836) Ph: 845-565-7770 Fax: 845-562-8963

Website: roofvents.com Email: sales@roofvents.com

5778-10

Tail Pipe Installation With Roof Vent

Page 1 of 3

Step 1:

Turn the vent upside down and make a

cardboard template from the ange. The

template should be the same size as the ange

with the hole in the middle.

Step 2:

Using the template, trace the square and circle

onto the roof as shown.

Step 3:

Remove cardboard template to show the

square and circle pattern.

Step 4:

Using a reciprocating saw cut out a hole in the

roof deck and remove all debris.

Installation Instructions for RBV-8-C4-TP

PAGE 1
Installation Instructions for RBV-8-C4-TP Page 1 of 3 Tail Pipe Installation With Roof Vent Step 1: Turn the vent upside down and make a cardboard template from the flange. The template should be the same size as the flange with the hole in the middle. Step 2: Using the template, trace the square and circle onto the roof as shown. Step 3: Remove cardboard template to show the square and circle pattern. Step 4: Using a reciprocating saw cut out a hole in the roof deck and remove all debris.
PAGE 2
Installation Instructions for RBV-8-C4-TP Page 2 of 3 Tail Pipe Installation With Roof Vent Step 5: Once the hole is cut reach in the attic and pull up the Duct through the hole. Step 6: Insert the bottom of the Tail Pipe to the Flex Duct. Step 7: Using a Zip Tie secure the Flex Duct to the Tail Pipe. Step 8: Put roofing sealant on the underside along the bottom edge of flange as shown. Active Ventilation Products, Inc.
PAGE 3
Installation Instructions for RBV-8-C4-TP Page 3 of 3 Tail Pipe Installation With Roof Vent Step 9: Push the Flex Duct back into the attic, then lift shingles to insert flange underneath. Step 10: With the vent in place secure the flange to the shingle roof using a screw gun or drill. 10A: Required screw: #10 x 1.5" steel sheet metal screw. Total number of screws required = 12 Step 11: This is how the Round Back Vent should look when finished. Diameter of Opening 8" [20.31cm] 1" [2.54cm] 1" [2.