Technical data

B ODY AND L EGS (BODY PAD Mode)

➤ Slide mode switch to the OFF position.

➤ Thoroughly clean the treatment area.

➤ Cut any long hairs short.

➤ Place the rectangular shaped pad onto treatment area.

➤ Push white lead clip onto rectangular pad button.

➤ Place circular conductivity pad near the rectangular pad.

➤ Push on the green lead clip.

NB: Only the rectangular pad will give treatment. There are 2 white lead clips so you

can use 2 rectangular pads at the same time. See replacement pads section on

page 7.

➤ Slide mode switch to BODY PAD position.

➤ Make sure the red power light comes on.

➤ The 10 minute treatment time begins. Repeat the process again

so that complete treatment is 20 minutes.

NB: If skin becomes pink during first treatment, this is quite normal. Repeat the

ten minutes treatment the following day. Successful treatment is cumulative - the

more you use, the better the results. DO NOT however, exceed maximum

recommended use.

➤ Sit down and relax - read a book or watch TV.

➤ The green LED light comes on. After 5 minutes a beep will sound to indicate first

part of treatment is finished and the green LED light will flash to indicate 1 minute

rest period.

➤ Do not remove pads

➤ A beep will sound to indicate the start of the second stage of treatment (5 minutes).

➤ Three beeps indicate end of complete treatment and green LED light goes out.

➤ Slide mode switch to OFF.

➤ Carefully remove pads and stick them onto special silicon

plastic sheet provided.

➤ Remove hairs with e-PEN tweezers, or your own tweezers

if you prefer.

➤ Repeat treatments until hair is permanently removed.

• PROBE

• OFF

• FACE PAD

• BODY PAD

• PROBE

• OFF

• FACE PAD

• BODY PAD

• PROBE

• OFF

• FACE PAD

• BODY PAD

ePEN_Instruction6_04 6/16/04 1:55 PM Page 12