OWNER’S MANUAL Revision 1.3 www.ActiveForever.
AquaGuard Owner’s Guide RJE Technologies, Inc. TABLE OF CONTENTS INTRODUCTION ......................................................................................................... 1 About This Manual.................................................................................................. 1 Contacting RJE Technologies, Inc.......................................................................... 1 SAFETY PRECAUTIONS ..............................................................................
AquaGuard Owner’s Guide RJE Technologies, Inc. TERMS AND CONDITIONS OF WARRANTY The AquaGuard™ Pool Alarm System manufactured by RJE Technologies, Inc. is warranted to be free from defects in workmanship and materials under normal use and service when correctly installed, used and maintained. This limited warranty is subject to the following conditions and qualifications. Duration of the Warranty: AquaGuard™ products are warranted for a period of three (3) years from the date of purchase.
AquaGuard Owner’s Guide RJE Technologies, Inc. SAFETY PRECAUTIONS Important! The AquaGuard system is a pool alarm; not a life-saving device. It should be used along with other safety equipment and precautions. It is intended to provide an additional level of security to your pool and/or spa. This device is not intended to replace any other safety consideration; that is, adult supervision, lifeguards, fences, gates, pool covers, locks, and so forth, and some devices may not detect gradual entry.
AquaGuard Owner’s Guide • • RJE Technologies, Inc. Sensor Tube Check: Check the sensor tube monthly to ensure it is secure and damagefree (no cracks, breaks, deformation, etc.). Make sure the bottom of the sensor tube is 5 - 6 inches (13 – 15 cm) below the surface of the water. Add water to the pool, or install the Sensor Tube Extension (see System Components on page 4 for more information) if needed.
AquaGuard Owner’s Guide RJE Technologies, Inc. ABOUT THE AQUAGUARD POOL ALARM SYSTEM The AquaGuard Pool Alarm System is designed to detect a child, pet or object of a minimum size falling into a pool or spa. The system monitors the movement of water caused by a fall into the pool or spa by detecting changes in water pressure.
AquaGuard Owner’s Guide RJE Technologies, Inc. AquaGuard Operating Modes Detector Keypad – A PIN code places the detector unit in standby for swimming, arms the detector and clears an active alarm. Indication Condition Detector Unit Remote Unit Response “ARMED” Mode Red LED blinks once every two seconds Green LED shows “ARMED” Mode is the normal operating mode for the AquaGuard a steady series of system.
AquaGuard Owner’s Guide RJE Technologies, Inc. Assembling the Detector Base Unit and Sensor Tube You must assemble the Sensor Tube and Detector Unit before installing the unit at poolside. Installing Two Detector Units in a Pool The AquaGuard Pool Alarm System can be configured with two Detector Units when required due to pool size or to accommodate a vanishing edge (Infinity) type design, as shown on the following page. 1. Remove the screw from the front fitting of the Detector Unit.
AquaGuard Owner’s Guide RJE Technologies, Inc. • The Detector Unit's "anti-theft" alarm will sound if the Unit is dismantled while the system is on. Enter 1234 on the Detector unit keypad to deactivate the "anti-theft" alarm. Extreme environmental conditions (strong wind, heavy rain) can affect AquaGuard’s performance, or in rare cases, cause a false alarm. The time required to return to “armed” mode under these conditions may be longer than normal.
AquaGuard Owner’s Guide RJE Technologies, Inc. STEP 2 - Position the Detector Unit at the Chosen Site • Place the Detector Unit at the installation site so the Sensor Tube extends into the water. • Make sure the bottom of the Sensor Tube is between 5 - 7 inches (13 – 18 cm) below the water’s surface.
