User Manual
CORPAK
MedSystems
INSTRUCTIONS FOR NG AND J-TUBE USE
INSTRUCTIONS FOR G-TUBE USE
1 0
1 0
1 0
10 cc
syringe
1 0
NG
Tube
• Fill tube with a recommended
initial dosage of 2-6 cc of the
CLOG ZAPPER solution.
• Fill syringe to
10 cc mark with
water (7.1 cc).
PLUG
tube.
• Keep
APPLICATOR
and
SYRINGE
together with
patient if procedure
must be repeated.
Remove
applicator
from tube.
• If tubing cannot be flushed,
REPEAT steps #4. thru #8.
• Alw
ays check with physician to
determine how many times the
process can be repeated.
After tube clears . . .
• Di
spose per
institution’
s
protocol
• an
d
R
ESUME
FEEDING.
STORAGE REQUIREMENTS
•
CLOG ZAPPER, once reconstituted, should be used
within 24 HOURS.
•
REFRIGERATE mixture while not in use.
CAUTION
•
Protective eyewear is strongly suggested. CLOG ZAPPER
can cause irritation if it gets in contact with the eyes.
•
Cut APPLICATOR at dot.
•
Discard excess tubing.
•
Place APPLICATOR into G-TUBE’s Administration Set port.
•
Continue with NG TUBE INSTRUCTIONS above.
INSTRUCTIONS FOR LOW PROFILE DEVICES
•
Place FEEDING SET into LOW PROFILE DEVICE following manufacturer’s instructions.
•
Place APPLICATOR into FEEDING SET.
•
Continue with NG TUBE INSTRUCTIONS above.
5840D 09-08
© 1996
6 cc
syringe
Fill syringe
completely.
CLOG ZAPPERCLOG ZAPPER
ApplicatorApplicator
CLOG ZAPPER
Applicator
Pump Set
NG Tube
• Turn feeding
pump OFF and
close roller
clamp on
administration
set.
®