Owner manual

ManualsBrandsActiveforever ManualsAccessories for waterGlobal Lift Commercial Series Portable Lift 450

DROP IN ANCHOR METHOD

C-375/C-450

COMMERCIAL SERIES LIFTS

INSTALLATION MANUAL

The Drop In Anchor System does not allow for a bond. You can

Bond directly to the li with the bonding lug provided or some

alternate means. Please contact your local electrical inspector

Before installing any anchoring systems

active forever

.com

FITNESS, SAFETY & MEDICAL SUPPLIES

Summary of content (6 pages)

PAGE 1
DROP IN ANCHOR METHOD C-375/C-450 COMMERCIAL SERIES LIFTS INSTALLATION MANUAL The Drop In Anchor System does not allow for a bond. You can Bond directly to the lift with the bonding lug provided or some alternate means. Please contact your local electrical inspector Before installing any anchoring systems active forever.
PAGE 2
DROP IN ANCHORING METHOD C-375/C-450 COMMERCIAL SERIES LIFTS PACKING LIST • 3 – Drop In Anchor’s • 3 – ¾”x 1” Bolts • 1 – T – Shaped Template • 3 – Black Caps • 1 – Bonding Lug w/ nut & bolt
PAGE 3
ADA GUIDELINES FOR POOL LIFT PLACEMENT •Pool Lift Location. Pool lifts shall be located where the water level does not exceed 48 inches (1220 mm). Seat Location. In the raised position, the centerline of the seat shall be located over the deck and 16 inches (405 mm) minimum from the edge of the pool. The deck surface between the centerline of the seat and the pool edge shall have a slope not steeper than 1:48. •Clear Deck Space.
PAGE 4
Distance must be 12 to 17”” From water’s edge Front Holes Hole’s parallel with water’s edge STEP 1: Locate the Drop In anchoring system template (included and shown above) • Once you determine where your lift is going to be located place the template down So you can mark on the concrete where you will need to drill the holes. • The dimensions are as follows: Front of Template must be 12” to 17” From the water’s edge. Also make sure that the front holes are parallel to the pools edge.
PAGE 5
15.00 8.00 15.00 Step 2: You will need a 7/8” rock carbide drilling bit. • Make sure you have accurately marked your hole location to be drilled. After drilling Your holes they must be 2 1/2” deep. Double check your measurements they should be: Front holes 8” from centerline from hole to hole (see above). The measurement from front to back should be 15” from Centerline of each hole (see above). Clean hole with pressurized Air or a vacuum.
PAGE 6
Picture A Picture B STEP 3: • Administer Epoxy into the hole prior to inserting the drop in anchor. • Drive the anchor ﬂush with the surface of concrete (shown in picture A) • Expand the anchor with the setting tool (provided). Anchor is properly expanded when shoulder of the setting tool is ﬂush with the top of the anchor (shown in picture B). • Global Lift has provided a bonding lug that you will need to drill & attach to the lift, due to there is no means to bond to the drop in anchor’s.