COMMERCIAL SERIES LIFTS C-375/C-450 RETRO-FIT ANCHORING METHOD INSTALLATION MANUAL active forever.
RETRO-FIT ANCHORING METHOD C-375/C-450 COMMERCIAL SERIES LIFTS PACKING LIST • 3 – Threaded Anchor’s with base • 3 – ¾” Nuts • 3 – ¾”x 1” Bolts • 3 – Bonding lugs w/nut & bolts • 3 – Plastic Caps • 1 – T – Shaped Template
ADA GUIDELINES FOR POOL LIFT PLACEMENT •Pool Lift Location. Pool lifts shall be located where the water level does not exceed 48 inches (1220 mm). Seat Location. In the raised position, the centerline of the seat shall be located over the deck and 16 inches (405 mm) minimum from the edge of the pool. The deck surface between the centerline of the seat and the pool edge shall have a slope not steeper than 1:48. •Clear Deck Space.
Distance must be 12” to 17” From water’s edge Front Holes Hole’s parallel with pool’s edge STEP 1: Locate the retro-fit anchoring system template (included and shown above) • Once you determine where your lift is going to be located place the template down so you can mark on the concrete where you will need to drill the holes. • The dimensions are as follows: Front of the Template must be 12” to 17” from the water’s edge, also make sure that the front holes are parallel to the pools edge.
15” 15” 8” Step 2: You will need a 4” diameter core drilling bit. • Make sure you have accurately marked your hole location to be drilled. After drilling Your holes they must be 6” deep and flat on the bottom of the hole (shown above). Clean Out the debris and make the holes are free from concrete. Double check your measurements they should be: Front holes 8” from centerline from hole to hole (see above).
Note: Anchor must be Electrically bonded. Please See the NEC requirements. Picture A Picture B STEP 3: Assemble the template with the 3 threaded anchor rods. • Place a ¾” nut on top of each threaded rod, then place the template on top and bolt Down with the ¾” bolts provided (refer to picture A). • Place the assembly in your drilled holes as shown in picture B.
Picture B Picture A STEP 4: Cementing the anchor in the concrete. • You will need 20lbs of Quick dry Anchoring Cement (Commercial Grade Quikrete Exterior Use Anchoring Cement) to complete the installation. You can purchase at any hardware store in your area. Read the label and follow manufacturer’s instructions. • Start pouring into the 3 holes evenly until you fill them up, make sure not to overfill the Holes so that it does not create more work to scrap excess concrete off.