User Manual

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • 6 – 1
6
3DUW &KU\VOHU+LVWRULF'LDJQRVWLFV
This section covers most non-OBD II (OBD I) compliant
Chrysler vehicles manufactured from 1989 – 1995.
✓ Due to different processor calibrations used, the function list for a particular
vehicle may or may not appear as shown. Based on the vehicle information
entered, the tool automatically detects the computer system installed.
✓ If an Operating Error message displays, make sure the adapter cable is
securely attached, and the ignition key is ON. Cycle the ignition key to OFF for
10 seconds, then ON. This may be required to reset the computer. If required,
select YES to try again. If the problem still exists, refer to “Error Messages”
on page 7-3.
READ CODES
The Read Codes function enables the tool to retrieve and display any specific
emission-related Diagnostic Trouble Codes (DTC) stored in vehicle’s memory.
This function also retrieves DTCs that failed one trip but did not turn on the MIL
light. The function can be performed KOEO or KOER.
Select Read Codes from the Chrysler
Functions list and press
(17(5 .
Perform the following.
1) Set Parking Brake
2) Turn Key On-Engine Off or Running.
3) Put Transmission In Park Or Neutral.
Keep hands and Tools away from fan and engine during
test.
If no DTCs have been stored in vehicle’s
memory, a System Pass screen displays.
:DKE>7DG@5F;A@E ^
[ S&736A67E
SD3E7A67E
]
S*;7I3F3 
!
CAUTION
'KEF7?$3EE
"A3G>FE7F75F76X
