Operating Instructions

To erase codes from the vehicle computer:

1. Set the ignition to Key On and Engine Off. Do NOT start the

vehicle. The engine should not be running.

2. Press and hold the ERASE key for 3 seconds then release, or

Select Erase Codes from Diagnostic Menu and press

ENTER.

3. Whentheconrmationmessageappearsonthedisplay,choose

one of the following options.

• To proceed with the operation: Press

ENTER for YES.

• To cancel the operation and return to the Diagnostic Menu:

Press BACK for NO.

The Tool will automatically perform the Read Codes function after

erasing codes. The Tool will then indicate the number of codes

remaining.

If after erasing codes a DTC returns, the problem has

notbeenxedorotherfaultsarepresent.

System Setup

System Setup allows:

• Display contrast to be changed,

• Tool information to be viewed,

• Display to be checked,

• Operation of the keypad to be checked,

• Memory of the Tool to be checked,

• Language to be changed,

• Units of measure to be changed.

• Long PID Names to be enabled/disabled

Long PID Names

Long PID Names allows the user to enable/disable the tool scrolling

the complete PID name on the bottom line of the display while viewing

Live Data or viewing Freeze Data.

 FromtheSystemSetupmenu,usethe▲UPor▼DOWN

arrow keys until Long PID Names is highlighted, then press

ENTER.

SelectONorOFFasdesiredusingthe▲UPor▼DOWN arrow

NOTICE