Instruction Manual

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • 3 – 19
Using The Scan Tool
3
Recording
The Recording function is used to play back a recording.
✓ This function is very similar to View Data. The only difference is that
View Data is real time viewing of PIDs, while Recording is a viewing
of previously recorded PIDs.
From the Review Data menu:
1.Select Recording.
•Use
UP or DOWN
arrow key until Recording is
highlighted.
2. Play Back Recording.
✓ The Recording has frame
number and timestamp (in
seconds).
❒ Negative frames and
timestamps indicate data
recorded before trigger event.
❒ Positive frames and
timestamps indicate data
recorded after trigger event.
❒ Use UP or DOWN arrow keys to view recorded PID data
of each frame.
❒ Use LEFT or RIGHT arrow keys to scroll back and forth
through frames.
❒ See Appendix A for PID Definitions.




=====================
I/M Monitors
DTCs (Codes)
State OBD Check
Recording
View Fre eze Data 
02 Monitor Tests
Review Data
I/M Monitors
ON
MIL STATUS
ABS TPS(%) 100
ENGINE (RPM) 688
A/F RATIO 14:1
CALC LOAD 83.1
FRAME:0 TM 0.0