User Manual

573904 | REV. B | 03.2016
Bosch Automotive Service Solutions Inc.
CP9670 AutoScanner®
|
User guide | 15
|
en
• Use the and keys until Review Data is
highlighted.
• Press .
Diagnostic Menu
O2 Monitor Tests
Diagnostic Monitor Tests
On-Board Systems
Charging System Monitor
Vehicle Information
Component Locator
Acronyms
Review Data
Code Lookup
Rd\Er
2. Follow prompts and instructions provided by scan tool
and then select item whose data you wish to review.
• The Review Data menu shows a checkmark next
to the item(s) that has data.
• If there is not a checkmark next to the item,
then this item can’t be selected until the appro-
priate function is run from the Diagnostic Menu.
• See “Recording” on page 15 for detailed
instructions on this function.
Recording
The Recording function is used to play back a recording.
This function is very similar to View Data. The only differ-
ence is that View Data is real-time viewing of PIDs, while
Recording is a viewing of previously recorded PIDs.
From the Review Data menu:
1. Select Recording.
• Use the and keys until Recording is
highlighted.
• Press .
Review Data
✓DTCs (Codes)
✓State OBD Check
✓Recording
✓View Freeze Data
✓O2 Monitor Tests
✓Diagnostic Monitor Tests
✓Vehicle Information
✓I/M Monitors
Rd\Er
2. Select Playback Recording.
• Use the and keys until Playback
Recording is highlighted.
• Press .
Playback Options
Long PID Names
English/Metric
Playback Recording
Rd\Er
• The recording has frame number and timestamp
(in seconds).
– Negative frames and timestamps indicate
data recorded before trigger event.
– Positive frames and timestamps indicate
data recorded after trigger event.
– Use the and keys to view recorded
PID data within each frame.
– Use the key to scroll back and forth
through frames.
– See “Appendix A—PID Definitions” on page 34.
• Different vehicles communicate at different
speeds and support a different number of PIDs.
Therefore, the maximum number of frames that
can be recorded varies.
ABSLT TPS(%)
CALC LOAD(%)
COOLANT(°C)
ENG SPEED(RPM)
EQ RATIO11
FUEL SYS 1
FUEL SYS 2
IAT(°C)
IGN ADV(°)
0.0
0.0
-40
0
1.999
N/A
N/A
-40
0.0
Frame: Time: -3.8-1
3. Return to Review Data menu.
• Press .
4.7 Code Lookup
Code Lookup is used to look up definitions of DTCs
stored in the scan tool. The scan tool can be powered
from vehicle or from a PC using USB to use the Code
Lookup function.
From the Diagnostic menu:
1. Select Code Lookup.
• Use the and keys until Code Lookup is
highlighted.
• Press .