User Manual

en
|
16
|
User guide
| CP9670
AutoScanner®
573904 | REV. B | 03.2016
Bosch Automotive Service Solutions Inc.
Diagnostic Menu
Diagnostic Monitor Tests
On-Board Systems
Charging System Monitor
Vehicle Information
Component Locator
Acronyms
Review Data
Code Lookup
System Setup
Rd\Er
2. Select the appropriate module for the code.
• The Select Module screen may not be shown
for every vehicle. If not shown, the DTC will be
looked up as OBDII/EOBD.
Select Module
Engine
ABS
All of the Above
OBDII/EOBD
3. Enter code.
• All characters must be entered.
• Only one character can be changed at a time.
• Use to advance to the next digit.
• Use the and keys to change the
selected digit.
• Press .
Code Lookup
P2122
moves to next digit
alters selected digit
• If the definition could not be found, the scan
tool displays “No DTC Definition Found.” See
Service Manual.
4. To look up another DTC, press .
5. Press again to return to the Diagnostic Menu.
4.8 Locating Data Link Connector
• The OBDII data link connector (DLC) is usually
located under the driver’s side dash.
• Refer to vehicle user manual for DLC location.
• For more information, go to http://www.obdclear-
inghouse.com/oemdb.
4.9 Connect the Tool
1. Locate the OBDII data link connector (DLC) under
the steering column. If the connector is not there, a
label should be there indicating the whereabouts of
the connector.
2. If necessary, remove the cover from the vehicle
connector.
3. Turn the ignition switch to the ON position. Do not
start the engine.
4. Plug the OBDII connector attached to the tool into
the DLC.
5. The tool will attempt to identify the vehicle. If suc-
cessful, the vehicle identified will be displayed. If
vehicle couldn‘t be identified, menus will be shown
for you to select the vehicle manually.
The tool can support one previous vehicle in the
garage. If you already have a previous vehicle in your
garage, the tool will automatically overwrite the
previous vehicle with the currently selected one. All
previous scanned data in Review Data will be a
combination of all previous vehicles. Run all func-
tions again to ensure that all data was scanned from
the current vehicle.
6. Review Quick Test results.
7. Go to Diagnostic Menu by pressing .
4.10 Vehicle Selection
If the scan tool failed to identify the vehicle, or if
was pressed from the Diagnostic Menu, the Vehicle
Selection screen will appear.
1. Use the and keys to select AutoID™,
Manual or Prev:.
• If the vehicle is a model year 2000 or newer,
select AutoID.
• If the vehicle is 1999 or older, or if the vehicle is
2000 to 2004 but does not support AutoID™,
select Manual and go to Step 3.
• If the previously tested vehicle listed after Prev:
is desired, select Prev:. If this is the first time
the tool has been used, the space after Prev:
will be blank.
• Press .