User Manual
Table Of Contents
- 1 Safety Precautions
- 1.1 Read All Instructions
- 2 Important Safety Warnings and Instructions
- 3 Getting Started
- 4 Using the Scan Tool
- 5 Diagnostic Menu
- 6 Troubleshooting
- 7 Appendix A—PID Definitions
- 8 Appendix B—Glossary
- 9 Limited Warranty
573904 | REV. B | 03.2016
Bosch Automotive Service Solutions Inc.
CP9670 AutoScanner®
|
User guide | 19
|
en
3. Select the component.
• Use the and keys until the desired
component is highlighted.
• Press .
Component Locator
A/T Control Solenoid Valve Asse
ABS Control Module
Accelerator Pedal Position Sens
Camshaft Position Sensor
Clutch Pedal Position Sensor (M
Crankshaft Position Sens
EGR Solenoid Valve
Engine Coolant Temperature Sens
A/T Control Solenoid Valve Assem
4. View selected component location.
Component Locator
A/T Control Solenoid Valve
Assembly
In the automatic transmission
• Press to return to the Diagnostic Menu.
5 Diagnostic Menu
The first time the scan tool links to the vehicle, the
communication protocol is automatically detected, and
is used until the scan tool is turned off or another vehi-
cle is diagnosed.
If an error message displays, make sure the DLC cable is
attached and the ignition key is on. Cycle ignition key to OFF
for 10 seconds, then ON. This may be required to reset
computer. If required, select YES to try again. If problem still
exists, refer to “Error Messages” in Troubleshooting.
The scan tool keeps all data received from the last vehi-
cle selected until any of the following occurs:
• A new vehicle is selected.
• Scan tool is flash programmed to update software.
On initial link to vehicle, scan tool checks the status of
I/M Monitors no matter which function is selected.
IMPORTANT
Review Data, Code Lookup, and System Setup
are covered in Section 4 of this manual. These
items are not covered in this section.
The Diagnostic Menu is broken down into the following selections:
• I/M Monitors
• Read Codes
• Erase Codes
• MIL Status
• State OBD Check
• View Data
• Record Data
• View Freeze Data
• Drive Cycle Monitor
• O2 Monitor Tests
• Diagnostic Monitor Tests
• On-Board Systems
• Charging System Monitor
• Vehicle Information
• Component Locator
• Acronyms
• Review Data
– I/M Monitors
– DTCs (Codes)
– State OBD Check
– Recording
– View Freeze Data
– O2 Monitor Tests
– Diag Monitor Tests
– Vehicle Information
• Code Lookup
• System Setup
– English/Metric
– Language Setup
– Long PID Names
– Tool Information
– Display Test
– Keypad Test
– Memory Test
– Program Mode