User Manual

en
|
22
|
User guide
| CP9670
AutoScanner®
573904 | REV. B | 03.2016
Bosch Automotive Service Solutions Inc.
MIL
Indicates that this DTC has turned on the
MIL light.
Pending
Pending codes are also referred to as
continuous monitor or maturing codes.
An intermittent fault causes the control
module to store a code in memory. If the
fault does not occur within a certain num-
ber of warm-up cycles (depending on ve-
hicle), the code clears from memory. If
fault occurs a specific number of times,
the code matures into a DTC and the MIL
illuminates or blinks. This function can be
used with KOEO or KOER.
Non-MIL
DTC that is not emission-related and did
not turn on the MIL light.
MIL Code
This DTC type also has a number with it
indicating that this is the code number
turning on the MIL. Vehicle service man-
uals may refer to this number instead of
the one listed in the DTC number field.
Permanent
Permanent codes are a special type of
confirmed code. Permanent codes be-
gan being reported by vehicles around
2010, and therefore not supported by ev-
ery vehicle. While Confirmed Codes can
be erased by the Tool, Permanent Codes
cannot. Permanent Codes are erased by
the vehicle when the vehicle has deter-
mined the fault is no longer present.
Active
DTC that was present at the time of scan
tool request.
Stored
DTC that was not present at the time of
scan tool request.
4. Return to Diagnostic Menu.
• Press .
5.3 Erase Codes
The Erase Codes function deletes DTCs and resets I/M
Monitor data from vehicle’s control module(s). Perform
this function key on engine off (KOEO). Do not start the
engine.
The Erase Codes function may also erase View Freeze
Data, O2 Monitor Tests, and Diagnostic Monitor Test
results depending on vehicle.
The Erase Codes function sets monitors to inc.
Perform Erase Codes function only after systems have
been checked completely and DTCs have been written
down.
After servicing the vehicle, erase stored DTCs and verify
no codes have returned. If a DTC returns, problem has
not been fixed or other faults are present.
Depending on which monitor sets a code the vehicle
may need to be driven and the monitor ran before con-
cluding that the fault is repaired.
From Diagnostic Menu:
1. Select Erase Codes.
• Use the and keys until Erase Codes is
highlighted.
• Press .
Diagnostic Menu
I/M Monitors
Read Codes
Erase Codes
MIL Status
State OBD Check
View Data
Record Data
View Freeze Data
Drive Cycle Monitor
Rd\Er
• Alternately, press and hold the key for 2
seconds when appears on the display.
• If diagnostic results and codes are not to be
erased select NO and press .
Erase Codes
Are you sure you want to
erase diagnostic results and
codes?
No Yes
Rd\Er
• Selecting NO displays a “Command canceled”
message.
Erase Codes
Command canceled
Press ENTER to continue
Rd\Er
2. Select YES to erase diagnostic results and codes.
• Press .
Erase Codes
Are you sure you want to
erase diagnostic results and
codes?
No Yes
Rd\Er
3. If more than one module is supported, a menu is
displayed.