User Manual

573904 | REV. B | 03.2016
Bosch Automotive Service Solutions Inc.
CP9670 AutoScanner®
|
User guide | 23
|
en
• Use the and keys until the desired
choice is highlighted.
• Press .
Select Module
Engine
ABS
OBDII/EOBD
4. Observe “Command sent” message is displayed.
• Press .
Erase Codes
Command sent
Codes remaining:36
Press ENTER to continue
Rd\Er
5. Return to Diagnostic Menu.
• Press .
5.4 MIL Status
From Diagnostic Menu:
1. Select MIL Status.
• Use the and keys until MIL Status is
highlighted.
• Press .
Diagnostic Menu
I/M Monitors
Read Codes
Erase Codes
MIL Status
State OBD Check
View Data
Record Data
View Freeze Data
Drive Cycle Monitor
Rd\Er
2. View MIL Status.
MIL is ON
MIL lamp should be ON if
engine is running
Press ENTER to continue
Rd\Er
3. Return to Diagnostic Menu.
• Press .
5.5 State OBD Check
The State OBD Check function is used to display a basic
status of the vehicles OBD system.
• Malfunction indicator lamp (MIL) status
• Codes found
• I/M monitors
Erase Codes deletes DTCs and resets I/M monitors from
vehicle’s computer module(s).
The State OBD Check function has the following areas:
• MIL Status ON or OFF
• Number of Codes Found
• Number of Monitors OK
• Number of Monitors Inc
• Number of Monitors N/A
State OBD Check should be done with the key on
engine running (KOER) due to showing MIL status.
The number of codes found are OBDII/EOBD confirmed
codes and permanent codes. Pending codes are not
included.
The number of monitors that are either ok, inc, or na are
only Since DTCs Cleared and not This Drive Cycle.
Refer to Read Codes and I/M Monitors for more
detailed information about the results.
From Diagnostic Menu:
1. Select State OBD Check.
• Use the and keys until State OBD
Check is highlighted.
• Press .
Diagnostic Menu
Read Codes
Erase Codes
MIL Status
State OBD Check
View Data
Record Data
View Freeze Data
Drive Cycle Monitor
Rd\Er
I/M Monitors
2. View State OBD Check display.