User Manual

en
|
24
|
User guide
| CP9670
AutoScanner®
573904 | REV. B | 03.2016
Bosch Automotive Service Solutions Inc.
State OBD Check
Codes Found
Monitors OK
Monitors Inc
Monitors N/A
MIL Status
18
3
5
3
ON
Rd\Er
3. Return to Diagnostic Menu.
• Press .
5.6 View Data
The View Data function allows real time viewing of the
vehicle’s computer module’s parameter identification
(PID) data. As the computer monitors the vehicle, infor-
mation is simultaneously transmitted to scan tool.
View Data allows the following items to be viewed on
the scan tool:
• Sensor data
• Operation of switches
• Operation of solenoids
• Operation of relays
Apart from Read Codes, View Data is the most useful
diagnostic function for isolating the cause of a vehicle
operation problem.
From Diagnostic Menu:
1. Select View Data.
• Use the and keys until View Data is
highlighted.
• Press .
Diagnostic Menu
Read Codes
Erase Codes
MIL Status
State OBD Check
View Data
Record Data
View Freeze Data
Drive Cycle Monitor
Rd\Er
I/M Monitors
2. Observe while the scan tool validates PID list.
Validating PIDs
Validating PID List
PID 7/329
Please Wait
• PID MAP validation is the tool asking the vehicle
which PIDs are supported. See “Appendix A—PID
Definitions” on page 34 for a complete list of
PIDs supported by the tool.
• Multiple PIDs may be sent if vehicle is equipped
with more than one computer module (for
example a powertrain control module [PCM]
and a transmission control module [TCM]). The
scan tool identifies them by their identification
names (ID) assigned by manufacturer (i.e. $10
or $1A).
• If one or more control module stops responding,
the scan tool displays a message.
– If continuing, dashes will replace data in
right-hand column.
– If NO is selected, the scan tool attempts to
re-establish communication with that mod-
ule.
From Select Data to View menu:
1. Select Entire Data List.
• Use the and keys until Entire Data List
is highlighted.
• Press .
Select Data to View
Long PID Names
English/Metric
Entire Data List
Rd\Er
2. View PIDs on scan tool.
• Use the and keys.