User Manual
Table Of Contents
- 1 Safety Precautions
- 1.1 Read All Instructions
- 2 Important Safety Warnings and Instructions
- 3 Getting Started
- 4 Using the Scan Tool
- 5 Diagnostic Menu
- 6 Troubleshooting
- 7 Appendix A—PID Definitions
- 8 Appendix B—Glossary
- 9 Limited Warranty
573904 | REV. B | 03.2016
Bosch Automotive Service Solutions Inc.
CP9670 AutoScanner®
|
User guide | 29
|
en
5.11 Diagnostic Monitor Tests
The Diagnostic Monitor Test function is useful after
servicing or after erasing a vehicle’s memory. Test results
do not necessarily indicate a faulty component or system.
• Non-CAN vehicles Diagnostic Monitor Test receives test
results for emission-related powertrain components
and systems that are not continuously monitored.
• CAN vehicles Diagnostic Monitor Test receives test
results for emission-related powertrain components and
systems that are and are not continuously monitored.
• Vehicle manufacturer is responsible for assigning
test and component IDs.
From Diagnostic Menu:
1. Select Diagnostic Monitor Test.
• Use the and keys until Diagnostic
Monitor Test is highlighted.
• Press .
Diagnostic Menu
MIL Status
State OBD Check
View Data
Record Data
View Freeze Data
Drive Cycle Monitor
O2 Monitor Tests
Diagnostic Monitor Tests
On-Board Systems
Rd\Er
• Applicable diagnostic monitor tests are displayed.
2. Review test results displayed on scan tool.
• Use the and keys until desired result is
highlighted.
• Press .
• Non-CAN example:
Select Diag Mon Test
Test $49
Test $4A
Test $62
Test $76
Test $78
Test $81
Test $9A
Test $9B
Test $03
Rd\Er
• CAN example:
Select Diag Mon Test
O2 Sensor B1S2
Catalyst B1
Purge Flow Mon
HO2 Sen B1S2
Misfire Data
Misfire Cyl 1
Misfire Cyl 2
Misfire Cyl 3
O2 Sensor B1S1
Rd\Er
Or, refer to appropriate vehicle service manual for
test IDs and definitions.
• On Non-CAN vehicles the scan tool displays:
– Test data (test ID)
– Maximum value (MAX)
– Test measurements (MEAS)
– Minimum value (MIN)
– Status (STS)
– Measurements and Specification values are
hexadecimal numbers (i.e., $1A, $FE, $11.)
– Module (MOD)
Test $03
MOD
MAX
MEAS
MIN
ID
$09
----
00
00
STS OK
01
Rd\Er
• On CAN vehicles scan tool displays:
– Test performed. The test performed can be
$## if test is not defined. Refer to vehicle
service manual for details.
– Measured values and units of measured
(such as volts, amps, and seconds).
– Status of monitor test data.
– Module ID where the monitor test data
came from.
Purge Flow Mon
MOD $00
MAX 32.767(KPa)
MEAS 0.110(KPa)
MIN 0.000(KPa)
STS OK
Test $C9
Rd\Er
3. Return to Select Test menu.
• Press .
4. Return to Diagnostic Menu.