User Manual
Table Of Contents
- 1 Safety Precautions
- 1.1 Read All Instructions
- 2 Important Safety Warnings and Instructions
- 3 Getting Started
- 4 Using the Scan Tool
- 5 Diagnostic Menu
- 6 Troubleshooting
- 7 Appendix A—PID Definitions
- 8 Appendix B—Glossary
- 9 Limited Warranty
en
|
30
|
User guide
| CP9670
AutoScanner®
573904 | REV. B | 03.2016
Bosch Automotive Service Solutions Inc.
• Press .
5.12 On-Board Systems
The On-Board Systems test allows the scan tool to con-
trol operation of vehicle components, tests or systems.
• Some manufacturers do not allow tools to control
vehicle systems. A vehicle not supporting an on-
board system is identified by a message that is
displayed when selected.
• Refer to the vehicle service manual for on-board
systems instructions.
• The manufacturer is responsible for determining the
criteria to automatically stop test. Refer to appropri-
ate vehicle service manual.
From Diagnostic Menu:
1. Select On-Board Systems.
• Use the and keys until On-Board Sys-
tems is highlighted.
• Press .
Diagnostic Menu
State OBD Check
View Data
Record Data
View Freeze Data
Drive Cycle Monitor
O2 Monitor Tests
Diagnostic Monitor Tests
On-Board Systems
Charging System Monitor
Rd\Er
• A list of on-board systems and components
available for testing are shown on the display.
2. Select test.
• Use the and keys until desired test is
highlighted.
• Press .
On-Board Systems
Rd\Er
EVAP Systems Test
3. Return to On-Board Systems menu.
• Press .
4. Return to Diagnostic Menu.
• Press .
5.13 Charging System Monitor
The Charging System Monitor function allows the ccan
tool to provide voltage measurements at the DLC to give
an indication of battery, starter, and alternator perfor-
mance.
From the Diagnostic Menu:
1. Select Charging System Monitor
• Use the and keys until Charging Sys-
tem Monitor is highlighted.
• Press
Diagnostic Menu
View Data
Record Data
View Freeze Data
Drive Cycle Monitor
O2 Monitor Tests
Diagnostic Monitor Tests
On-Board Systems
Charging System Monitor
Vehicle Information
Rd\Er
2. Turn the ignition key ON but do not start the engine.
• Press .
Charging System Monitor
Turn the key on.
Do NOT start the engine.
Press ENTER to continue
3. The DLC voltage is measured at KOEO.
• The screen below shows a KOEO voltage of
11.4V.
Charging System Monitor
DLC KOEO Voltage:
11.4V
Press BACK to exit.
Please start the engine.
• Start the engine, or press BACK to return to the
Diagnostic Menu.
• The scan tool will monitor the DLC voltage and
progress to step 4 if starter cranking is detected.