Data Sheet

PQ12 Actual Size
Benefits
→ Compact miniature size
→ Precise position feedback
→ Limit switches
→ Simple control
→ Low voltage
→ Equal push/pull force
→ Easy mounting
Applications
→ Robotics
→ Consumer appliances
→ Toys
→ RC vehicles
→ Automotive
→ Industrial Automation
Miniature Linear Motion Series · PQ12
Actuonix Motion Devices unique line of Miniature Linear Actuators enables a new
generation of motion-enabled product designs, with capabilities that have never
before been combined in a device of this size. These tiny linear actuators are a
superior alternative to designing your own push/pull mechanisms. Their low cost
and easy availability make them attractive to hobbyists and OEM designers alike.
The PQ12 actuators are complete, self contained linear motion devices with
position feedback for sophisticated position control capabilities, or end of stroke
limit switches for simple two position automation. Driving them couldn’t be
easier, simply apply a DC voltage to extend the actuator, and reverse the polarity
to retract it. Several gear ratios and voltage options are available to give you
varied speed/force configurations.
PQ12 Specifications
Gearing Option 30:1 63:1 100:1
Peak Power Point 15N @ 15mm/s 30N @ 8mm/s 40N @ 6mm/s
Peak Efficiency Point 8N @ 20mm/s 12N @ 12mm/s 20N @ 8mm/s
Max Speed (no load) 28mm/s 15mm/s 10mm/s
Max Force (lifted) 18N 45N 50N
Max Side Load 5N 10N 10N
Back Drive Force 9N 25N 35N
Stroke 20 mm
Input Voltage 6 or 12 VDC
Stall Current 550mA @ 6V, 210mA @ 12V
Mass 15g
Operating Temperature
-10°C to +50°C
Positional Repeatability
±0.1mm
Mechanical Backlash 0.25 mm
Audible Noise 55dB @ 45cm
Ingress Protection IP-54
Feedback Potentiometer
5kΩ±50%
Limit Switches Max. Current Leakage: 8uA
Maximum Duty Cycle 20%
Basis of Operation
The PQ12 is designed to push or pull a load along its full stroke length. The speed of travel
is determined by the load applied (see load curves). When power is removed the actuator
will hold its position, unless the applied load exceeds the back drive force. Repeated
stalling of the actuator against a fixed load will shorten the life of the actuator. Since
application conditions (Environmental, loading, duty cycle, vibration, etc) vary so widely,
we advise application specific testing to determine the expected life of the actuator.
Ordering
Small quantity orders can be placed directly online at www.Actuonix.com. Each actuator
ships with two mounting brackets, M3 mounting hardware, and one FPC ribbon cable
connector. To extend the length of the ribbon cable you can purchase one of our PQ12
cable adapters and extension cable, or solder wires directly to the ribbon cable. Contact
[e-mail] for volume quotes and customization options for OEM’s.
Copyright 2016

Actuonix Motion Devices Inc.