Owner manual

INSTALLATION

DRO 200E

Checking Voltage and Connecting Power

Check that the voltage available at the power source is within specification before

connecting it to the readout. If required, set the voltage selector to match the line

voltage.

CAUTION

Connecting the readout to a power source outside

of the acceptable range, or making an inappropri-

ate setting with the voltage selector, may damage

the readout, the scales, or both.

1. Remove the caution label from the

input module, and use a thin-blade

screwdriver in the slot at the top of

the power-input module to open the

module cover.

2. Pull the selection block out.

Rotate the block 180° so the

proper voltage setting will be

seen through the window of

the cover.

3. Remove the fuse, move the shorting

bar to the other side, install the prop-

er fuse, and push the block back into

place.

4. Close and snap the cover shut.

Opening Slot

The voltage setting will show through the window in the voltage selection cover.

Connect the readout to the power source using the power cord supplied.