User guide

MICRO-LINE Reference Manual

SCALE INSTALLATION

13. Move the axis to align reading head mounting holes.

14. A gap must exist between the reading head and the

mounting surface.

15. Adjust the leveling screws, using a .001" -.003" feeler

gage (or shim) between the leveling screw and the

mounting surface. Adjust the leveling screw until a slight

drag is felt on the feeler gage. Repeat this for each leveling

screw, 3 total.

16. Evenly tighten the two 8-32 SHCS to secure the reading

head.

17. Use the Allen wrench from the leveling screw adjustment to

slide brackets away from the reading head.

18. Remove the alignment brackets and save with this Reference

manual.

19. Route cable with slack loops allowing for axis motion.

20. Secure excess cable by fastening with clips and ties.

21. Move the axis through its full travel. Confirm that the

assembly does not interfere with the machine movement.

MLMmanual.QXD 2/12/02 5:01 PM Page 5