Instruction Manual

PROGRAM STEPS
MILLPWR
®
• Select a tool offset by pressing the appropriate softkey.
• Enter the feed rate.
• If you need to program a 2
ND
corner and/or a tilt angle or would like to program a
finish cut, press the
MORE softkey. Otherwise, press the USE key.
2
ND
Corner
Enter the X- and Y-axes coordinates for the 2
ND
corner. (The 2
ND
corner must be located diagonally
across from the 1
ST
corner.)
Tilt Angle
Enter the tilt angle.
Finish
Highlight "Cut" in the“Finish” field. Enter the
amount of material to be removed during the finish cut.
Enter the feed rate for the finish cut.
For “Direction,” press either the
CW softkey for clockwise or the CCW
softkey for a counter-clockwise direction.
Press the
USE key.
Note: If the tool size and type listed in the "Tool" field are incorrect, change the tool
settings before running the program (refer to Programming a Tool Step).
Operation Manual
5-16