Instruction Manual

PROGRAM STEPS
MILLPWR
®
• If you would like to program a finish cut, press the
MORE softkey. Otherwise, press the USE key.
Finish
Enter the amount of material to be removed
during the finish cut.
Enter the feed rate for the finish cut.
Select the finish cut's direction. Press the
CW soft-
key for clockwise or the
CCW softkey for a counter-clockwise
direction.
Enter a step over percentage (how much you want the tool to overlap on each
pass).
Press the
USE key.
Note:
If the tool size and type listed in the "Tool" field are incorrect, change the tool
settings before running the program (refer to Programming a Tool Step).
Operation Manual
5-26