Instruction Manual

PROGRAM STEPS
MILLPWR
®
Operation Manual
5-35
Repeat
Using this step you can repeat whole programs or sections of programs horizontally,
vertically or both.
T
o program a repeat:
• From the PGM screen, press the MORE STEPS
softkey.
• Press the REPEAT softkey.
• Enter the number of the first step and the last step
in the step range that you want to repeat.
T
ip:
Use the TEACH POSITION softkey to indicate
the X and Y offsets.
• Enter the offset along the X- and/or Y-axes.
(The offset is the distance between repeats.)
• Enter how many times you want to repeat the
original shape.
Note:
The steps being repeated must precede the
“Repeat” step.
Note:
Entering a 0 (zero) for the number of repeats will change the location of the
original steps entered in the FROM and TO fields. To shift the datum of an
entire program, place a repeat step at the end of the program and enter the
required coordinate shift(s) in the X-, Y-, and/or Z-axis fields. When USE is
pressed the entire program will shift by the entered values.