Instruction Manual

ManualsBrandsACU-RITE ManualsControl panelMILLPWR 2 Axes

121

122

123

124

125

126

127

128

129

130

PROGRAM STEPS

MILLPWR

Operation Manual

5-41

• Enter the feed rate.

• Press the EDIT TEXT softkey.

• Notice that the screen

is divided into two sections—

“Text Block” and “Char-

acters.” You can switch

from one to the other by

pressing either the

TEXT

BLOCK

or CHARACTER soft-

key. Use the arrow keys

to move around within each

section.

• In the “Character” section, highlight a letter, number, symbol or space. Press the

ENTER key to make a selection. (The alphabet block on the left side represents

capital letters; the block on the right side represents lowercase letters.)

To add a space, move the cursor to a blank spot anywhere within the

“Characters” box and press the

ENTER key.

You can edit text by pressing the

TEXT BLOCK softkey. Highlight the character

you want to edit, and then press one of the following:

The

CLEAR key will delete a character.

The

DELETE LINE softkey will erase the entire line of text that the cursor

is in and move all following text lines up.

The

INSERT LINE softkey will insert a blank text line, moving existing

text lines down.

The

CLEAR ALL softkey will erase all of the text within the text block.

• When you have finished creating/editing the text, press the

EDIT TEXT softkey

(or press the USE key) to return to the “Engrave” screen. MILLPWR will display

the text that you have created on the right.

• Press the

EDIT TEXT softkey if you want to make changes, or press the USE

key to add the engraving step to the program.