Instruction Manual

PROGRAM STEPS

MILLPWR

Operation Manual

5-48

• Press the MORE STEPS softkey again.

• Press the CHAMFER softkey.

• MILLPWR will automatically fill in the "From" and

“To” fields in “Steps” for you. (Press the

CONTOUR softkey if you want to chamfer the end of

a contour with the beginning.)

• Enter the distance from the common point of both

lines. ("Length 1" refers to the line listed in the

"From" field; "Length 2" refers to the line listed in

the "To" field.) If you plan to use an angle, enter

only one length.

• If you entered one length above, highlight the

"Angle" field and enter the chamfer's angle from the

X-axis; otherwise, leave it blank.

• Adjust the feed rate, if necessary.

• Press the

USE key.