Instruction Manual

PROGRAM STEPS
MILLPWR
®
Operation Manual
5-53
If you need to program a start angle or would like to program a finish cut,
press the
MORE softkey. Otherwise, press the USE key.
Start Angle
You will want to program a start angle if the begin-
ning point of your spiral on the print is tilted—that
is, not positioned at a 0 degree angle (3 o'clock).
Highlight “Start Angle,” then enter the angle of
the spiral’s starting position (measured from the
X-axis).
Finish
Enter the amount of material to be removed during the finish cut.
Enter the feed rate for the finish cut.
Select the direction for the finish cut. Press the
CW softkey for clockwise or the
CCW softkey for a counter-clockwise direction.
Press the USE key.
Note:
If the tool size and type listed in the "Tool" field are incorrect, change the tool
settings before running the program (refer to Programming a Tool Step).