Instruction Manual

PROGRAM STEPS
MILLPWR
®
Operation Manual
5-60
Change Steps
The “Change Steps” feature gives you the ability to change or edit the depth, offset
and feed rate of several steps simultaneously.
Note:
You can use this feature from anywhere within the program—you don't need
to highlight a specific step within the step range.
T
o use the “Change Steps” feature:
• From the PGM screen, press the STEP FUNCTIONS softkey.
• Press the
CHANGE STEPS softkey.
• Enter the first and last step numbers that you would like to change in the
“Step Range” field.
• Highlight each field that you want to change and enter the new data.
• Press the
USE key.
Note:
It’s a good idea to highlight the changed steps in the program sequence,
then press the ENTER key. Each step should include the new settings.