Instruction Manual

SETUP

MILLPWR

Operation Manual

7-3

If you need to,

change the

units (inches or

mm) for the tool

you are using

before you set

the length.

Using the tool library without repeatable tool lengths:

To enter a tool into the Tool Library:

• From Setup, highlight “Tool Library” then press

ENTER.

• Highlight a blank row in the Tool Library and press

ENTER.

• Enter the tool’s diameter.

• Highlight the “Type” field.

• Press the

TOOL TYPES softkey.

• Highlight the tool type that describes the tool being used.

Press

ENTER.

• Press the

USE key.

• Continue with Setup or press the

USE NEW SETTINGS softkey.

o edit an existing tool:

• From Setup, highlight “Tool Library” then press ENTER.

• Highlight the tool you want to edit, then press

ENTER.

• Make the necessary changes, then press

USE.

• Continue with Setup or press the

USE NEW SETTINGS softkey.