Instruction Manual

SETUP
MILLPWR
®
Operation Manual
7-22
Serial Port
You can connect
MILLPWR to a PC via the serial port (located on the rear of the operator
console). The serial port allows you to store part programs on a PC.
To activate the serial port:
• From Installation Setup, highlight “Serial Port”
and press ENTER.
• Press the REMOTE STORAGE softkey to change
the “Function” setting from “Off” to “Remote
Storage.”
• Highlight “Baud Rate.”
• Define the Baud rate by pressing the
LOWER or
HIGHER softkeys. The Baud rate you select must
match the PC’s Baud rate.
• Highlight “Handshaking.”(The handshaking feature verifies that MILLPWR and the
PC are communicating properly during file transfers.)
• Press the
ENABLED softkey.
• Press the
USE key.
• Continue with Setup or press the USE NEW SETTINGS softkey.