Instruction Manual

SETUP
MILLPWR
®
Operation Manual
7-30
The signal test shows when an axis was last tuned and whether or not the digital-to-analog
converter is emitting an analog signal. When the test is complete, either “Pass” or “Fail”
will appear in the “Signal Test Result” field. If a failure is reported, check the message bar
prompt for details.
Signal Test
To enable or disable the motor assembly monitor:
• From the Diagnostics screen, highlight "Motor Assembly Monitor" and press ENTER.
• Press either the ENABLED or DISABLED softkey. (If the ENABLED softkey is selected,
the motor assembly monitor display will appear on the DRO screen.)
• Press the
USE key.
• Continue with Diagnostics or press the
USE NEW SETTINGS softkey.
To display the signal test:
• From the Diagnostics screen, highlight "Signal Test"
and press ENTER.
• Press the softkey for the appropriate axis.
• Press the
EXIT TEST softkey to close the “Signal
Test” screen.
• Continue with Diagnostics or press the
USE NEW
SETTINGS softkey