Instruction Manual

PROGRAM STEPS
MILLPWR
®
Position/Drill
The position/drill function will move the table to the position
you want based upon your X- and Y-axes coordinates.
T
o program a position/drill step:
• Press the POS key.
• Enter the X- and Y-axes coordinates.
• Enter a depth.
• Press the
USE key.
Note
: If the tool size and type listed in the "Tool" field
are incorrect, change the tool settings before run-
ning the program (refer to Programming a Tool
Step).
Center Line
With the position/drill feature, you can also locate the midpoint of
two points or the center line of a circle.
T
o locate a center line:
• Press the CENTER LINE softkey.
• Locate the first edge and press the
ENTER key.
• Locate the second edge of your part and press the
ENTER key.
• If you are calculating the center of a circle, locate and enter a third point along
the diameter of the circle.
• Press the
USE key.
Operation Manual
5-6
If you use an
electronic edge
finder, the points
will automatically
be entered on
contact—even if
you over-travel.