Manual

AMI Reference Manual

If you are not using the J2 or J4 connec-

tor on the AMI, you must wire a jumper

at this time to close the circuitry.

Otherwise, when you power on

MILLPWR

and the AMI, an emergency stop condi-

tion will automatically occur and

neither system will run.

Remote Go provides a switch input that can be used in place of the operator

pressing the

GO key. Pins 5 and 6 (J2) are reserved for this function.

Note:

The Remote Go input signal must be held for a minimum of

0.2 seconds in either ON or OFF mode in order for it to be recog-

nized by the AMI.