Instruction Manual

4 1 Introduction

1.1 MILLPWR

E-STOP and Shutdown

The E-STOP is used for emergency program shut down by turning off

the servo motors. It does not shut down the spindle motor. The

spindle motor must always be manually stopped using the spindle

switch to stop the motor, and the cutting tool.

 When the E-STOP button is pressed, the servo motors

are stopped, and the quill can be raised.

 When the STOP key is pressed once, the servo motors

pause, but are still active. All axes are locked, and can

not be moved.

 The program can now either continue by pressing the

GO key, or stopped by pressing the STOP key a second

time.

 If the STOP key is pressed a second time canceling the

program, the spindle motor must be stopped, and the

tool raised before moving any of the remaining axes.

Shutting down the MILLPWR

system is done by using the Shutdown

soft key.

 Press the Shutdown soft key to shut down the

MILLPWR

system. This soft key is available in both

DRO and PGM mode.

 Confirm the shut down by pressing the Yes soft key.

 Press the No soft key to cancel and exit the shut down

procedure.

Always shutdown the MILLPWR

before turning power

off to the machine. Refer to the builder's instructions for

for additional information on turning power off.