Instruction Manual

ACU-RITE MILLPWR
G2
47
4.1 Tool Table
Editing an existing tool
To edit an existing tool is similar to adding a new tool using the same
dialogues.
 Highlight the desired field of the tool to be changed.
 Type in the new value, then press the ENTER key.
 When all changes have been made, press the Exit soft key, or USE
key to save changes to the tool table.
When running G-code programming, the tool length for each tool in
the program is provided from the tool table. As an example, T1 M6
prompts the operator to load tool 1 into the spindle. The tool length
and diameter offset are retrieved for tool #1 in the tool table, and used
to adjust the tool path and Z axis position. This is repeated for each tool
used.
Tool Table Structure
Tool table: Standard tool data
Only add the tool diameter and length if it is repeatable
each time it is selected.
Abbr. Inputs
Tool Number by which the tool is called in the
program (e.g. tool 2 = T2).
Diameter Compensation value for the tool diameter D.
Length Compensation value for tool length L.
Type Tool type: A popup menu appears where you
can select the type of tool being used.
D. Wear Tool diameter wear value.
(Only used in G code programs)
L. Wear Tool length wear value.
(Only used in G code programs)
Plunge Angle Angle of plunge cut.
(Only used in G code programs)