Instruction Manual

ACU-RITE MILLPWR

6.1 Conversational Programming

Setting the skew angle with an electronic edge finder:

Press the Datum softkey to open the DATUM dialogue. Highlight the

Angle field.

 Press the Probe soft key.

Touch off on two or more points along any single straight edge of your

part. You’ll notice that the Angle and Points fields change as you enter

points.

 Press the Finish soft key.

 Press the USE soft key to accept all of the points and

return to the DRO screen. Press CANCEL to return to

the DRO screen without accepting any points or

affecting your previous skew angle.

The Clear Angle soft key will reset the Angle, and the Points fields to

zero.

Using Teach:

Move the table so that a mechanical indicator rests against any

straight edge on the part. Press the Teach soft key to enter your

coordinate.You’ll notice that the Points change.

Now move the table so that the mechanical indicator touches another

point on the same straight edge. Press the Teach soft key. You’ll notice

that the Angle and Points fields change.

Repeat this process for any additional points.

 Press the USE soft key to accept all of the points and

return to the DRO screen. Press CANCEL to return to

the DRO screen without accepting any points or

affecting your previous skew angle.