User's Manual

ROAM/SSG – A Division of Acuity Brands
2ADCB-ACWIFI001User’s Manual
THIS DOCUMENT IS ROAM/SSG PROPRIETARY Page 10/13
3. Antenna Information
To maintain compliance with FCC Rules and Regulations, only the following
antenna types with gains no higher than what is indicated may be used with this
product:
For 2.4 Ghz Operation:
Flex Trace, max gain: 2.79 dBi
Omni, max gain: 1.0 dBi
For 5 Ghz Operation:
Flex Trace, max gain: 3.38 dbi
Omni, max gain: 2.4 dBi
4. RF Exposure Limit Warning
To comply with FCC’s RF exposure limits for general population / uncontrolled
exposure, the antenna(s) used for this transmitter must be installed to provide a
separation distance of at least 20cm from all persons and must not be co-located
or operating in conjunction with any other antenna or transmitter.
Pour se conformer aux limites d'exposition aux RF pour la population générale /
incontrôlée l'exposition, l'antenne (s) utilisée pour ce transmetteur doit être
installé pour Prévu distance de séparation d'au moins 20cm de toutes les
personnes et ne doit pas être situé ou opérant en conjonction avec une autre
antenne ou émetteur.
5. Compliance Statement (Part 15.19)
This Device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that
may cause undesired operation.
2ADCB -ACWIFI001 Frequency Selection
The 2ADCB -ACWIFI001 can select an unoccupied portion of the spectrum at
startup. The module also uses DFS to avoid interfering with Radar signal in 5
GHz to 5.8 GHz band. The series uses a set of channels as defined by the IEEE
802.15.11 / standards which span a range from 2405 to 2475 MHz and 5170
MHz to 5825MHz. See below for the list of between channels: