User's Manual

ROAM/SSG – A Division of Acuity Brands
2ADCB-ACWIFI001User’s Manual
THIS DOCUMENT IS ROAM/SSG PROPRIETARY Page 6/13
6
GND
Ground
3.3VDC
3.6VDC
7
PM_TXD
Power metering
communication
3.3VDC
3.6VDC
8
PM_RXD
Power metering
communication
3.3VDC
3.6VDC
9
PWR
Power input 3.3VDC
3.3VDC
3.6VDC
10
PWR
Power input 3.3VDC
3.3VDC
3.6VDC
11
PMW1
0-10V dim control
3.3VDC
3.6VDC
12
PM_RST
Power metering
communication
3.3VDC
3.6VDC
13
MCUDBGRX
UART debug RX
3.3VDC
3.6VDC
14
MCUDBGTX
UART debug TX
3.3VDC
3.6VDC
15
GND
DC communication
Ground
3.3VDC
3.6VDC
16
YAMAR_DATA_PWR
DC communication
Line
3.3VDC
3.6VDC
2. Operation of the 2ADCB -ACWIFI001 Radio Modem
Communication with the 2ADCB -ACWIFI001 radio modem happens through
serial port. The baud rate is set to be 115200, 8N1.
2.1. Getting started
Open an instance of terminal software on a serial port with the above settings
and connect to the RF modem. Any command is single line followed by enter
command. Format of command is: command param1 param2 … <enter> At
startup pushing the enter key a few times is necessary until the reception of the
prompt string.
This device is always a WIFI client. The device will scan for AP starting from
channel 1 to 11 then it will continue on 5GHz band. The default key and
password is: XeraL2/kentspeed. This can be change after the device is
connected.
PTS Commands description:
help
sdk-version
xlog-info
xlog-level [<new_level>]
xlog-prefix [<element> ...]