User's Manual

Page 1 of 2
Acumen Model J
Fireplace Remote Control Installation Instructions
PLEASE LEAVE THE INSTRUCTIONS TO THE HOMEOWNER.
The Acumen Model J Remote Control is designed for use with decorative gas fireplace and wall heaters using
a millivolt gas valve.
The Model J Transmitter is a Two-button hand held transmitter, which turns the gas on/off. The display of the
transmitter shows the current room temperature, low battery indicator and "*Child-Proof*".
Installation Precautions:
The Model J Remote Control is tested safe when installed in accordance with this installation manual. It is your
responsibility to read all instructions before starting installation and to follow these instructions carefully during
installation.
The Model J Remote Control MUST be installed by a qualified service technician.
The Model J Remote Control is carefully engineered and MUST be installed only as specified. If you modify it
or any of its components, you may possibly cause a fire hazard.
Installation Instruction
1.0 Installing the Receiver
1. Make sure the slide switch on the Remote Receiver is at the OFF position.
2. Connect the wires to the TH and TPTH terminals of the Millivolt valve. See Figure 1.
3. Installing the Remote Receiver to a Wall Mount:
- Secure the Remote Receiver to the wall mount.
- Use the screws provided to secure the face blade to the Remote Receiver. See Figure 2.
4. Installing the Remote Receiver to a Fireplace:
- Secure the Fireplace Mounting plate to the base pan of the fireplace.
- Slide the Remote Receiver into the fireplace mounting plate. See Figure 3.
5. Put the switch cap to the slide switch.
6. Slide the battery compartment into the Remote Receiver. See Figure 4.
Figure 3
Figure 2
Installation of the
Receiver to a
Junction Box
Figure 1
TP TH TP TH
To Remote
control
FIREPLACE REMOTE
PRESS
TO OPEN
OFF
ON
REMOTE
BAT.LOW
BAT.LOW
OFF
REMOTE
ON