Owner's Manual Owner manual

−−
The band and frequency that the
radio was last tuned to is displayed.
To change bands, press the AM/FM
button. On the FM band, ST will be
displayed if the station is broadcast-
ing in stereo. Stereo reproduction on
AM is not available.
The SEEK function
searches the band for a station with
a strong signal. To activate it, press
the SEEK bar ( or ), then
release it. Depending on which side
of the SEEK bar you press, the
system scans upward or downward
from the current frequency. It stops
when it finds a station with a strong
signal.
You can use any of five methods to
find radio stations on the selected
band: TUNE, SEEK, SCAN, AUTO
SELECT, and the preset buttons.
The ignition switch must be in the
ACCESSORY (I) or ON (II) position
to operate the audio system. Turn
the system on by pressing the PWR/
VOL knob or the AM or FM button.
Adjust the volume by turning the
knob.
Use the TUNE knob to
tune the radio to a desired frequency.
Turn the TUNE knob to the right to
tune to a higher frequency, or to the
left to tune to a lower frequency.
Operating the Radio SEEKTUNE
Audio System
Comfort and Convenience Features
130
Main Menu
Table of Contents