Owner's Manual Owner manual

CONTINUED
Open the hood. If you need to
change a bulb on the driver’s side,
undo the three fasteners and
remove the air intake cover.
Remove the electrical connector
from the bulb by pulling the
connector straight back.
Remove the rubber weather seal
by pulling on the tab.
Unclip the end of the hold-down
wire from its slot. Pivot it out of
the way and remove the bulb.
Insert the new bulb into the hole,
making sure the tabs are in their
slots. Pivot the hold-down wire
back in place, and clip the end into
the slot.
Install the rubber seal over the
back of the headlight assembly.
Make sure it is right side up; it is
marked with an arrow.1. 2.
3.
6.
4.
5.
Lights
Maintenance
283
FASTENER
AIR INTAKE COVER
HOLD-DOWN WIRE
BULB
WEATHER SEAL
CONNECTOR
Main Menu
Table of Contents